This die will cut 1 x 4.5" / 11.43 cm Clip.
SNAP CLIP NEEDED: 90mm (3.5in ) or 100mm (4in)
The centre of the clip die is hollowed out to create the same shape of the actual snap clip. The hallowed out part is a bit wider than the snap clip, so a little bit of the metal will show. The fabric is glued onto the clip, depending on the type of fabric being used is the type of glue you will use.
MEASUREMENTS: The actual die 10 in x 3.5in This means it will fit even the smaller die cutting machines such as the cuttle bug. Will also fit Sizzix Big kick, Big Shot, Big Shot Plus, and the Big Shot Pro.
(Size of die is provided... this means even though it will fit the smaller machines extended cutting pads are required) Snap Clip shape is approx. 8.75 inches / 22.22cm so when folded 4.5"/ 11.43cm (gives extra room for gluing)
** REMINDER: THIS COPYRIGHT DESIGN WAS CREATED BY MONKEY BEAR CRAFT SUPPLIES. ANY INTENT TO STEAL OR COPY IS HIGHLY DISCOURAGED. IN THE ATTEMPT TO DO SO, NECESSARY ACTIONS WILL BE TAKEN.**
WHEN YOU PURCHASE THIS DIE YOU ARE AGREEING TO FOLLOW MBCS and OLIVER AND MAYS' TERMS OF PURCHASE.
TERMS OF PURCHASE:
YOU MAY USE THE CUT OUT OF THIS DIE TO CREATE AS MANY FINISHED PRODUCTS AS YOU WISH.
YOU MAY ALSO CUT OUT TEMPLATES FOR YOUR PERSONAL USE.
YOU MAY NOT MASS DISTRIBUTE THIS DESIGN.
YOU ARE NOT ALLOWED TO CREATE TEMPLATES FOR PROFIT OR TO GIFT.
YOU MAY NOT ALTER THE SIZE OF THIS DESIGN AND HAVE IT PRODUCED.
The centre of the clip die is hollowed out to create the same shape of the actual snap clip. **the hallowed out part is a bit wider than the snap clip so a little bit of the metal will show** (ive seen many clips at department stores that also have the same "issue") The fabric is glued onto the clip, depending on the type of fabric being used is the type of glue you will use. MBCS have tested clips for 3 months and none have come undone or unglued from the clip.